ZONARE Z.one Ultra SP, Service Manual, Page: 231 / 244

Q00180 Rev B Page 231 of 244
"Note: Copies are uncontrolled documents - For revision verification see the Master Documentation List"
STEPS:
1.
Disconnect the main interface ribbon cable, and DC power cable, from their connectors at the
rear of the DVD Drive.
2.
Remove the two (2) Torx screws that secure the upper-mount brace that retains the DVD drive
in position within the chassis
3.
Slide the DVD drive out from under the under the metal framework of the CEE chassis, and
remove the drive from the system.
4.
Position the replacement DVD drive into its mounting position in the chassis.
5.
Secure the DVD drive in place by reinstalling the upper-mount brace, using the two (2) Torx
screws.
CAUTION
DO NOT over-tighten these two screws, as it may result in putting excessive downforce on the top/front
of the DVD drive and cause the DVD media to not properly load into the drive.
6.
Reconnect the DVD interface and DC power cables.
7.
Reverse removal steps for installing replacement Scanner Deck. Note: cables need to be
secured to chassis using ty-wraps, upon re-assembly
IMPORTANT NOTE !
ONLY the following two types of media can be used in the DVD drive on the Z.ONEULTRA SP:
- DVD: DVD “ +R ” or “+RW ” Type (Not - type)
- CD: CD “ -R ” Type (Not + type)
System Verification:
STEPS:
1.
Reconnect the main AC power cord from the rear of the SmartCart SP or plug into the wall source.
2.
Place AC circuit breaker, located at the rear of the SmartCart SP, in the “ 1 ” (ON) position.
3.
Dock the scan engine on the SmartCart SP, and ensure it latches securely.