Q00180 Rev B
Page 196 of 244
"Note: Copies are uncontrolled documents - For revision verification see the Master Documentation List"
Display Cables Reconnection & Scanner Deck Installation:
STEPS:
1)
Reattach the display arm ground cable, and column ground cables to their mounting point on the
bottom of the upper support plate, using the retaining screw.
2)
Reconnect the Display’s power and video cables to the appropriate connectors on the Main Board.
CAUTION
The J1 video connector on the Main Board is a VERY high-precision style connector, with very
fine/fragile pins, and is surface-mounted to the PC board.
As such, extreme care MUST be observed to ensure proper alignment of the cable prior to
pressing into place, and only light pressure should be required for fully seating cable in
connector receptacle.
Failure to do so may result in permanent damage to the connector; requiring replacement of
the entire Main Board assembly.
3)
IMPORTANT
: IF the existing video cable and connector that was in the “old” display arm was
the previous generation design, it will look significantly different then the “new” cable design that
is in the replacement arm.
The direction of the main cable orientation at the time the connector on the cable is installed in the
mating connector on the Main Board, is facing in the opposite direction (toward the front of the
system), and is installed as shown below:
Summary of Contents for Z.one Ultra SP
Page 1: ......