Q00180 Rev B
Page 186 of 244
"Note: Copies are uncontrolled documents - For revision verification see the Master Documentation List"
13.
Once installation is complete, Tilt the Cart back up onto its wheels, and release the brake
mechanism.
14.
Verify smooth operation and pivoting of the Cart through all movements.
15.
Verify that the brake functions correctly and that each caster locks and the brake functions when
it is set.
20.3.2 19” Flatpanel Display - Removal/Replacement (SmartCart SP)
Required Parts
•
85021-00
Display Assy, SmartCart SP
•
32856-00
Overlay, SmartCart SP Display
•
Aluminum tape (EMC insulation)
Overview of Procedure
•
Removal of Display Assy
•
Installation of Display Assy
•
Verification of LCD Display, Speakers, and Microphone
Required Tools/Equipment
•
Long handled flat-blade screwdriver (3mm width blade, 12” shaft, thin blade)
•
9/32” Nut Driver or wrench
•
#1 Phillips Screwdriver
Procedure
Removal:
STEPS:
1.
Ensure the
Z.ONEULTRA SP
is powered “OFF”.
2.
Place AC circuit breaker, located at the rear of the SmartCart SP, in the “
0
” (OFF) position.
3.
Disconnect the main AC power cord from the rear of the SmartCart SP, or unplug from the
wall source.
4.
Remove the four (4) Phillips-head screws that are retaining the plastic display hinge back
cover, and remove back cover and center insert sleeve
.
Summary of Contents for Z.one Ultra SP
Page 1: ......