ZONARE Z.one Ultra SP, Service Manual, Page: 150 / 244

Q00180 Rev B Page 150 of 244
"Note: Copies are uncontrolled documents - For revision verification see the Master Documentation List"
16.7.8 Remote Software Upgrade (download) from ZONARE site
NOTES :
PRIOR to beginning a remote software download/installation process, it is
necessary to contact Zonare Technical Support, for assistance in setting up the
necessary software files on the FTP site, for each remote software upgrade
session.
The
Z.ONEULTRA SP
will need to be attached to an active direct internet
accessible networked connection, at the install site, in order to perform this remote
software upgrade procedure.
1.
Dock the Scan Engine in the SmartCart SP, and ensure the network port on the Rear I/O panel of
the SmartCart SP is connected to an active internet connection.
2.
Insert the USB Memory Stick to be targeted for downloading of the software installer files, into
one of the USB ports on the back of the SmartCart SP.
3.
Power on the system and allow it to fully boot.
4.
Using the “ Tab ” button and Menu Control on the SmartCart SP user interface, advance to the
“ Tools ” menu and then sequence through the following selection:
Tools tab --> System Setup --> Diagnostics
5.
Click on the CHECK AVAILABLE SOFTWARE softkey to open remote communications for
determining the available software for upgrade on the remote FTP site. A message should appear
on the screen, indicating the available software for download, and specifying the software revision
level that is posted.
6.
To begin the remote software downloading process, click on the UPGRADE softkey.
NOTE : The time required for downloading the complete software installer files to the USB
Memory Stick will be determined by the network speed at the facility. Typically the
download time is about 10 minutes.
7.
At the completion of the downloading of the software installation files to the local USB Memory
Stick, the system will put up a prompt on the screen. The prompt will offer the User the option of
performing installation of the new software on the scan engine.
8.
In order to start the software installation process, accept the offered prompt. The software
installation should begin, and will typically take less than 10 minutes to complete.
For information on the specific steps that will occur during the software install, refer to the section
on software installation elsewhere in this manual.