Q00180 Rev B
Page 134 of 244
"Note: Copies are uncontrolled documents - For revision verification see the Master Documentation List"
16.2 “
Advanced”
Software Installation Procedure
SPECIAL INFO
−
In cases where the revision level of the software on the
Z.ONEULTRA SP
is
being transitioned in a non-standard fashion, or has become corrupted and the
system will not boot to perform a normal software installation process, the
following advanced software installation steps should be used.
16.2.1 Interrupting the normal boot sequence (
“Alternate Boot Options”
):
1.
Connect a transducer to the Scan Engine (if not currently attached)
2.
Press the green power button, on the left-rear of the Scan Engine, and then IMMEDIATELY abort
the normal boot sequence by pressing the
“
Freeze
”
key, within a few seconds after pressing
the power button, and the start-up splashscreen first appearing.
NOTE
: The
“
Back
“
key also performs this function, if it is accessible due to the Scan Engine
being undocked or docked in a Cart
3.
The Scan Engine should abort the normal boot, and display a screen (shown below) offering a
variety of options.
Summary of Contents for Z.one Ultra SP
Page 1: ......