ZONARE Z.one Ultra SP, Service Manual, Page: 122 / 244

Q00180 Rev B Page 122 of 244
"Note: Copies are uncontrolled documents - For revision verification see the Master Documentation List"
IMPORTANT : To SAVE all of the newly configured settings, it is necessary to do the following
steps:
8.
“Roll” the jog dial until “ SAVE ” is displayed in the setup menu window.
9.
“Press” the jog dial control, and then “Roll” it to select which one of three possible user setup
types (1, 2 or 3) you wish to save.
10.
“Press” the jog dial to save the desired user settings type
11.
To manually exit out of the setup MENU, “Roll” the jog dial until “ BACK ” is displayed in the
setup menu window, and then “Press” the jog dial .
NOTE: The setup menu will exit, and automatically return to the normal “Ready” printer
state, when no new user actions are made on the jog dial for approximately 20
seconds.
# Setting Name Description Zonare Recommended Value
1
BEEP Audible Tone ON
2
CLEAN Initiate head cleaning operation n/a – control action in menu
3
COMD Selects printer driver version 897
4
DIR Direction (start top or bottom, for printing) NORMAL
5
FEED Added gap between prints ON
6
GAMMA Gamma curve (print density) 4
7
IMAGE Positive or Negative printout POS
8
INFO Printing of user settings on prints OFF
9
LOAD Loads stored settings 1, 2 or 3 into use n/a – control action in menu
10
MEDIA Paper type HG
11
MENU Prints out current user settings to paper n/a – control action in menu
12
QTY Number of copies to print 1
13
RSIZE Selects image enlargement to paper size ON
14
SAVE Saves settings (as user 1, 2 or 3) n/a – control action in menu
15
SHARP Sharpness: Image tuning (1-15) 4
16
SIDE Image rotation (Up or 90 degrees) SIDE
17
SPEED Print speed NORMAL
Figure 42: Menu Settings (UP-D897)