Q00180 Rev B
Page 199 of 244
"Note: Copies are uncontrolled documents - For revision verification see the Master Documentation List"
10)
Verification of microphone – TBD.
11)
Verification is complete – return system to normal operation.
20.3.4 Z-PAK Battery - Removal/Replacement (SmartCart SP)
Required Parts
•
P/N: 85031-00 Assy, Battery Pack, Gen II Cart
Required Tools/Equipment
•
#2 Phillips Screwdriver
•
#3 Phillips Screwdriver
Overview of Procedure
•
Removal Battery Pack
•
Re-installation of Battery Pack
•
Verification of system operation
Battery Pack Removal:
STEPS:
1.
Ensure no Scan Engine/Module is docked
2.
Place AC circuit breaker, located at the rear of the SmartCart, in the “OFF” position.
3.
Disconnect the main AC power cord from the rear of the SmartCart.
4.
Put the User Interface in the highest position.
5.
Set the front caster brakes to prevent system from rolling.
6.
Undock the scan engine from the Cart, and set aside.
7.
The Battery Pack is located under the system. For the easiest access, tilt the entire system forward
until is in horizontal position, resting on the front-side handles.
8.
Remove the four (4) smaller #2 Phillips-head screws that are retaining the Battery Pack to the
bottom of the SmartCart.
Summary of Contents for Z.one Ultra SP
Page 1: ......