Q00180 Rev B
Page 201 of 244
"Note: Copies are uncontrolled documents - For revision verification see the Master Documentation List"
13.
Remove the larger #3 Phillips-head screw, located on the right side of the mounting of the Battery
Pack to the bottom of the SmartCart (leaving the last two (2) #3 Phillips-head screws, on the left
side of the battery pack, still in place).
14.
Lower the battery pack slightly to enable access to the connector at the end of the battery pack
power cable, and unplug the connector from the power supply on the SmartCart.
15.
Remove the battery pack.
Battery Pack Re-Installation:
CAUTION
AC Power
MUST
be present and the circuit breaker MUST be in the “ON” (power applied to
the power supply of the SmartCart), at the time the Z-PAK is connector is plugged back into the
power supply connector.
Failure to do so may result in a high enough potential arcing during connection, that may
damage components on the power supply!
STEPS:
1.
Connect the main AC power cord to the rear of the SmartCart and a wall source.
2.
Place AC circuit breaker, located at the rear of the SmartCart, in the “ON” (“
1
” pushed in)
position.
3.
While holding the battery pack in position, plug the power connector into the receptacle on the
bottom of the power supply.
7.
While still supporting the weight of the battery pack attach the power cable to the mating
connector on the bottom side of the power supply module on the SmartCart.
Summary of Contents for Z.one Ultra SP
Page 1: ......