Q00180 Rev B
Page 228 of 244
"Note: Copies are uncontrolled documents - For revision verification see the Master Documentation List"
2.
Slide the plastic cosmetic sleeve downward as far as it will go, letting it slide over the bottom
panel insert.
3.
Pull the lift release lever and position the User Interface lift to its LOWEST position.
4.
Remove the two Phillips-head screws that retain the lower access cover panel.
5.
Remove the lower access panel cover by pulling inward on the edges to allow the ridges to
clear the frame, and then removing panel.
6.
In combination of accessing from the top and through the access holes in the bottom of the
SmartCart SP chassis, using the 5mm hex Allen wrench and 13mm socket, remove the lower
mounting hardware (bolt, nut and 2 spacers) that attaches the gas stock to the base bracket.
7.
Grasp the handles on the User Interface housing, and slide (lift) the upper portion of the
SmartCart SP to its most fully extended position to expose (above the top edge of the plastic
cosmetic sleeve) the top mounting point for the gas spring.
NOTE
: DO NOT pull the lift release handle while sliding (lifting) the User Interface housing
upward, as the bottom gas spring point is currently disconnected, and should raise
free of its mounting)
Summary of Contents for Z.one Ultra SP
Page 1: ......