Ziton ZP3, Installation Operation & Maintenance

Page: 157 / 239

ZP3 Fire Control Panel
Peer-to-peer 3 Protocol
ZP3 Fire Control Panel Manual
UD1160.9 Iss 6 (25/02/2005)
Page 9 - 7
I
9
9.8. Debug Comms Message
Please Note: “Level 4” implies highest-level responsibility personnel only.These are “basic
low-level initialization functions” for panel comms disable and comms configuration, and are
not to be used as final setup functions.
Typically it is likely in a final configuration that all the panel comms disable filters will be the
same across a system, and the “panels to be polled” config will be the same, but the comms
config filters will be different.
• If the “comms debug display” item is set to 5 or higher:
•
Pressing “Enable all” will also clear all the panel comms disabled filters to “enabled”,
and replicate across the network.
•
If the comms config setup is edited on one panel it will be replicated across the
network, accompanied by the panel comms disabled data, which must track it.
•
The comms debug view must be returned to 0 after use. It will automatically revert to 0
if the panel is rebooted.