Ziton ZP3, Installation Operation & Maintenance

Page: 58 / 239

ZP3 Fire Control Panel
ZP3 Panel
ZP3 Fire Control Panel Manual
Page 2 - 28 UD1160.2 Iss 6 (25/02/2005)
I
2
2.6.7 Auxiliary Boards and Modules
Available I/O auxiliary boards include ZP3AB-MIP8 (8-way input module), ZP3AB-RL8 (8-
way relay module), ZP3AB-MA8 (8-way sounder module, monitored), and ZP3AB-OP24 (24-
way open-collector transistor output module). These are illustrated below, and described in
detail on the following pages.
2.6.8 Printer
The ZP3 fire panel is designed for the simple mounting of an optional in-panel printer to
record all alarms, faults, and other events, including a record of operator actions. The printer
is depicted in the illustration below, with a description of the parts. A typical printout is also
shown.
For details on how to install paper and ribbon cartridge, see the "Operator" section. This
section also describes details of the printed messages.
Installing the Printer
If the printer is to be field installed, this is a relatively simple operation, as all necessary
connections are built into the panel. Nevertheless care must be taken, and the steps and
precautions shown below must be adhered to.
Once installed the printer must be configured to operate as required. It can be programmed
to print or suppress different types of messages (e.g. print "fire alarms", suppress "Disabled"
messages). This programming is done in the panel "Setup" menu, see the "Software
Configuration" section 5 for details.