Ziton ZP3, Installation Operation & Maintenance

Page: 124 / 239

ZP3 Fire Control Panel
Software Programming
ZP3 Fire Control Panel Manual
Page 6 - 16 UD1160.6 Iss 6 (25/02/2005)
I
6
System configuration: Relays
Menu Path: Setup\System Configuration|Relays
The System Configuration menu is used to set the common functions of the panel. The
"Relays" menu allows for the setup of the standard built-in relays.
Fire Relay The common fire relay can be set to normally de-
energised (open contact, closing on alarm) or normally
energised (closed contact, open on alarm). The latter
state is described as "inverted" in the menu.
Fault Relay The common fault relay can be set to normally energised
(open contact, closing on alarm) or normally de-
energised (closed contact, open on alarm). The latter
state is described as "inverted" in the menu.
RMC Alarm The remote manned centre output is connected to RMC-
routing equipment. It should be set to restore only after a
reset.
Sounder Relays The sounder outputs (4 outputs, controlled from 2
addresses) can be set to operate as "common", from any
alarm, or as programmable. If set to programmable, then
they must be linked to activating inputs in the I/O-menu.
System configuration: Printer
Menu Path: Setup\System Configuration|Printer
The System Configuration menu is used to set the common functions of the panel. The
"Printer" menu allows for the setup of the optional in-panel printer.
Printer type Allows the type of printer to be defined. Current types
are:
NONE (no printer attached)
Able24 (panel printer)
or IN (panel printer)
Serial desktop (external printer 80 column)
Printer options Defines the information to be printed. Categories are
"Fire Alarms", "Fault Alarms", "Panel Operations", and
"Outputs Active."