Zeiss Axioskop 2, Manual

Page: 60 / 140

START-UP
Attachments and conversions Axioskop 2 / Axioskop 2
MOT
2-28 B 40-075 e 06/98
2.2.12 Changing the technique modules
on the reflector turret
•
Remove cover (2-42/ 1 ) on the reflector turret by
pulling it forward.
•
Loosen two fixation screws (2-42/ 3 ) using
SW 2.5 ball-headed screwdriver and remove
technique module (2-42/
2 ) by pulling forward.
•
Place required technique module on the
guiding pins of the reflector turret and tighten
screws (2-42/
3 ).
•
Moving the reflector turret further by two
positions swings the attached technique
module in the beam path.
•
Attach the adhesive label in the respective area
on the cover.
•
Insert two upper holding elements of the cover at an angle and then fix the cover to the stand
housing via the lower holding elements.
2.2.13 Changing the filter set in the FL
reflector module
The filter sets for the FL reflector module can be
compiled and assembled by the customer himself
as required. The corresponding filter sets or
completely assembled FL reflector modules can be
ordered from Carl Zeiss.
•
Remove FL reflector module (2-43/ 3 ) from the
reflector turret (also see 2.2.12).
•
Use mounting device from the tool set to
unscrew retainer ring (2-43/
1 ).
•
Turn the reflector module around and allow the
filter (2-43/
2 or 4 ) to drop on a soft surface.
•
The barrier filter is inserted at (2-43/ 2 ), the
excitation filter at (2-43/ 4 ), and both are
secured using retainer ring (2-43/ 1 ).
Fig. 2-42 Changing of technique modules
Fig. 2-43 Changing the filter set in the FL
reflector module