Alar
m List
Alar
m Nu
mbe
r (4
00
0 to
4
9
99
)
Alarm List-797
other
If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
19
Arithmetic error occurred
when calculating acceleration
and deceleration during test
run in consideration of servo
delay for the Corner-R motion.
Setting error
(1)Check the following settings.
∙
Do not perform the conveyor tracking when using the Corner-R
motion.
other
If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
4540
JOB QUE EMPTY
ERROR
Setting error
(1)Check the following settings.
∙
Use
“
CALL QUE
”
under the condition that the job data is set to the
job queue.
other
If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
4541
INVALID INPUT
STRING(VAL)
1
There was no character string
representing a constant in
character string to be
extracted at VAL instruction
execution.
Setting error
(1)Check the following settings.
∙
Check the settings for the data of the character string to be extracted.
other
If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
4542
MRESET ERROR
1
An MRESET instruction was
executed while no endless
axis was designated.
Setting error
(1)Check the following settings.
∙
Set the endless axis.
other
If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
Alarm
Number
Alarm Name
Sub
Code
Meaning
Cause
Remedy
