Yamatake SDC35, User Manual

Page: 90 / 280

5-32
Chapter 5. DETAILED DESCRIPTION OF EACH FUNCTION
5 - 5 Set Point (SP)
The following shows the functional block diagram of the SP. For details about step operation,
refer to 5-6, Step operation .
Note
LSP is a local SP and shows that the data is retained inside this unit.
On the contrary, SP by the analog input from the outside is called RSP or remote
SP.
One LSP group exists.
Two or more LSP groups exist.
LSP system group
(Setting: Setup C30)
LSP1
(Setting: SP SP1)
DI Assignment is
not provided.
DI Assignment is
provided.
LSP value in use
SP
RSP
DI Assignment of LSP group
selection provided/not provided.
(Setting: DI Assignment di1.1 to
di3.1)
LSP group number
(Setting: LSP group
number in operation
display mode)
Logical operation of DI
(Setting: General DI
Assignment)
RSP input type
(Setting: Setup C10)
RSP high limit/low limit
alarm
(RSP mode only)
RSP scaling
(Setting: Setup C11 to
C12)
RSP ratio
(Setting: Parameter rA2)
RSP bias
(Setting: Parameter bI2)
RSP high limit/low limit
(-10 to +110% of scaling)
LSP/RSP mode selection
SP high limit/low limit
(Setting: Setup C07, C08)
SP ramp unit (Setting: Setup C32)
SP ramp-up/ramp-down (Setting: Parameter
SPU, SPd)
DI Assignment of SP ramp enabled/disabled.
(Setting: DI Assignment di1.1 to di3.1)
LSP 1 to 8
(Setting: SP SP1 to
SP8)