Yamatake SDC35, User Manual

Page: 3 / 280

i
To reduce risk of electric shock which could cause personal injury, follow all safety
notices in this documentation.
This symbol warns the user of a potential shock hazard where hazardous live voltages
may be accessible.
•
If the equipment is used in a manner not specified by the manufacturer, the protection
provided by the equipment must be impaired.
•
Do not replace any component (or part) not explicitly specified as replaceable by your
supplier.
•
All wiring must be in accordance with local norms and carried out by authorized and
experienced personnel.
•
A switch in the main supply is required near the equipment.
•
Main power supply wiring requires a (T) 500mA, 250V fuse(s) (IEC 127).
EQUIPMENT RATINGS
Supply voltages: 100 to 240Vac (operating power supply voltage 85 to 264Vac)
Frequency: 50/60Hz
Power consumption: 12VA maximum
EQUIPMENT CONDITIONS
Do not operate the instrument in the presence of flammable liquids or vapors.
Operation of any electrical instrument in such an environment constitutes a safety hazard.
Temperature:
0 to 50˚C
Humidity: 10 to 90%RH (non-condensing)
Vibration: 2m/s
2
(10 to 60Hz)
Over-voltage category: Category II (IEC60364-4-443, EN60664-1)
Pollution degree: 2
EQUIPMENT INSTALLATION
The controller must be mounted into a panel to limit operator access to the rear terminal.
Specifications of common mode voltage: The common mode voltages of all I/O except for main
supply and relay outputs are less than 33Vrms, 46.7V peak and 70Vdc.
STANDARDS COMPLIANCE
EN61010-1, EN61326
SAFETY REQUIREMENTS