Yamatake SDC35, User Manual

Page: 171 / 280

5-113
Chapter 5. DETAILED DESCRIPTION OF EACH FUNCTION
■
Input with motor fully closed and input with motor fully open
• When the control output type is R1 (motor drive relay output), the display and
setting can be performed. However, if [C57: Position proportional type] is set at
“2” (Estimated position control) or “3” (Estimated position c Position
adjustment at power ON), the display and setting cannot be performed.
• If you use the motor auto adjust function of the position proportional control,
these parameters can be set automatically. Additionally, they can also be set
manually in the same manner as described for normal set values.
Note
For details about motor auto adjust, refer to;
■
Motor auto adjust (on page 5-109) .
■
Motor full close–full open time
• When the control output type is R1 (motor drive relay output), the display and
setting can be performed.
• When using the motor auto adjust function of the position proportional control
with [C57: Position proportional type] set at “0” (MFB c Estimated
position control) or “1” (MFB control), the motor full close–full open time can
be set automatically. Additionally, this time can also be set manually in the same
manner as described for normal set values.
Note
For details about motor auto adjust, refer to;
■
Motor auto adjust (on page 5-109) .
• When [C57: Position proportional type] is set at “2” (Estimated position control)
or “3” (Estimated position c Position adjustment at power ON), the
actually measured motor full open time is set.
Item (Bank) Display Contents Initial value User level
Input with motor fully
closed
(Setup bank) 0 to 9999 1000 Basic,
Standard,
High function
Input with motor fully
closed
(Setup bank) 0 to 9999 3000
Item (Bank) Display Contents Initial value User level
Motor full close–full open
time
(Setup bank) 5.0 to 240.0s 30.0s Basic,
Standard,
High function