C
Daisy Chain Guide
C-13
3. Writing and transferring saved and newly made data
This section describes how to write or transfer data from the computer to a daisy-chained controller.
c
CAutIoN
the daisy chain function cannot be used concurrently with the tS-Monitor (lCD monitor option)
tS-X
tS-p
. If the
backup data with the lCD setting enabled is written, the communication may not be performed properly. If there
is a possibility that such data was written by mistake, perform automatic node number assignment again to
disable the lCD setting.
n
NOTE
• If a computer and a controller have already been connected, transfer and writing of data will be made to the
currently connected controller.
•
For details on how to write and transfer data to the controller, refer to the support software TS-Manager manual.
3.1 Writing data to controller
1
Select "Write Data to Controller...".
The "Write Data to Controller" dialog box appears.
TIP
You can also click the
[Write] button on the toolbar.
Writing data to controller
Select.
24C13-M0-00
2
Select the COM port.
Select the COM port to connect to the controller and click the [OK] button.
"Write Data to Controller" window
Select.
Click.
24C14-M0-00
