Xerox Legacy 4112, System Administration Manual

Page: 96 / 364

Xerox 4112/4127 Copier/Printer System Administration Guide 5-8
5. Using the Scan Service
Enabling the ports and setting the IP addresses
In order to use FTP service on the machine, enable the port and
set the IP address.The procedure for setting the machine is as
follows.
NOTE: The configuration can also be performed using
CentreWare Internet Services.
Refer to
“Using CentreWare Internet Services” on page 3-1
.
1.
Enter the System Administrator Mode (Chapter 1 Entering the
System Administrator Mode on page 1-15
.
)
2.
Enable the SNMP port.
a. Select
System Settings
.
b. Select
Connectivity & Network Setup
.
c. Select
Port Settings
.
d. Select
SNMP
and then select
Change Settings
.
e. Select
Port Status
and select
Change Settings
.
f. Select
Enable
and then select
Save
.
g. Select
Close
3. Enable the FTP client port and Internet service (HTTP) port as
above.
4. Select
Close
.
5.
If necessary, set the IP Address (Chapter 1 Setting the IP
address. on page 1-17).
6.
Exit the System Administrator Mode (Chapter 1 Exiting the
System Administrator Mode on page 1-16).
7.
After the machine is restarted, print out the
Printer Settings
List
to confirm that the ports are enabled and TCP/IP is
configured.