Xerox Legacy 4112, System Administration Manual

Page: 46 / 364

Xerox 4112/4127 Copier/Printer System Administration Guide 2-8
2. Configuration
Configuration on the machine (IPP)
This section describes the configuration procedure to enable
Internet Printing (IPP) on the machine. First enable the IPP port,
then set the IP address.
NOTE 1: The configuration can also be performed using IP
configuration tools included in CentreWare Internet Services or
CentreWare Utilities.
NOTE 2: Enable the SOAP port and the SNMP port in most cases.
Refer to
“Using CentreWare Internet Services” on page 3-1
.
1.
Enter the System Administrator Mode (Chapter 1 Entering the
System Administrator Mode on page 1-15
.
)
2.
Enable the IPP port.
a. Select
System Settings
.
b. Select
Connectivity & Network Setup
.
c. Select
Port Settings
.
d. Select
IPP
and then select
Change Settings
.
e. Select
Port Status
and select
Change Settings
.
f. Select
Enable
and then select
Save
.
3.
If necessary, set the IP Address (Chapter 1 Setting the IP
address. on page 1-17).
4.
Exit the System Administrator Mode (Chapter 1 Exiting the
System Administrator Mode on page 1-16).
5.
After the machine is restarted, print out the
Printer Settings
List
to confirm that the IPP port is enabled.
Configure the IPP as necessary. Refer to
“IPP” on page 3-16
for
the IPP configuration.
Configuration on the computer
See Chapter 2 Configuration on the computer on page 2-3.