Xerox 220, User Manual

Page: 147 / 280

Xerox Document Centre 220/230/332/340 User Guide Page 4-23
Fax
Fa
x
F
a
x
Super G3 to determine the communication mode to be used based on
the maximum capabilities of the remote fax machine. This
mode tries to
minimize the data transmission errors by using
Error Correction Mode (ECM). Initial communication speed
will be 33,600 Bits Per Second (bps).
G3 select the communication mode based on the maximum
capabilities of the remote fax machine, but initial
communication speed will be 14,400 bps. ECM is also used
with this option.
Forced 4800 bps In an area of low-quality communications, or when
experiencing telephone noise, the fax communications are
susceptible to errors. To
minimize errors, set the Document
Centre 220/230/332/340 to run at a communication mode of
4800. This mode is slower, but it is less susceptible to errors.
In some regional areas, the use of the Communication
Mode/Forced 4800 bps feature is restricted.
Delayed Start
Delayed Start is mainly used to transmit faxes during
off-peak hours when telephone charges are lower or when
sending to another country/time zone.
Use Delayed Start , to transmit a document to a single
destination, or use a broadcast send or polling operation. Up
to 100 delayed send jobs can be programmed at one time,
depending on the size of the documents and the available
memory. Use the
Fax Job Monitor feature to check the
available memory during transmission. Only one delayed
poll can be saved at a time.