88
Power Fail
The mains supply has been interrupted. Switch the collator off and on
again.
PSU voltage error:
There is a voltage error. Contact your local Watkiss service department.
Rear cover open
Check the rear cover/guard is fitted and is actuating the safety switch
correctly.
Remote stop
The Collator has stopped because there is a problem with ancillary
equipment to which it is linked. Clear the problem with this equipment
before restarting the job.
Set size wrong
The wrong number of bins are switched on for the job specified in Multiset.
The number of bins switched on must be a multiple of the number of
sheets in a set.
SFT Jam
There is a paper jam in the booklet maker. Open the booklet maker and
remove the jam.
SFT stalled
(SFT only)
There is a bad paper jam in the Stitch-Fold unit, one or more of the stitch
heads is jammed, or a fault has occurred.
Open the Stitch-Fold and clear any paper jams. If this does not work, lift
the perspex lid on the Stitch-Fold and release the drive to the Stitch Heads,
as follows:
* Undo the two star-shaped, orange drive lugs that sit just behind the
wire spools
* Slide each drive lug along the guide, until they are clear of the Stitch
Heads
* Hand-crank the machine to release the jammed Stitch head(s)
* Replace the drive lugs before starting the machine again
If this does not work, contact your local Watkiss service department.
SFT stalled
(BMP/TMP only)
There is a paper jam in the booklet maker. Open the booklet maker and
remove the jam.
Stacker full
The stacker is full of paper. Unload the stacker and touch
to continue
the job.
Stacker jam
There is a jam in the stacker. Clear the jam before restarting the job.
Stacker not connected
The stacker is not connected to the collator, and a job has been loaded
that requires the stacker to be in place.
Staple head err
A fault has occurred in the BookMaster or Rear Corner Stapler. Turn the
mains switch off and then on again. If the problem persists contact your
local Watkiss service department.
Message
Meaning
Summary of Contents for Vario
