Watkiss Vario, Operating Manual

Page: 91 / 110

87
Cannot start tray empty One of the switched-on bins was empty when was touched. Fill the
bin with paper and touch again.
Cannot start trim axis
changing The trim axis (size adjustment) of the trimmer is in the process of adjusting.
Wait for the trimmer to finish before pressing
.
Cannot start width axis
changing The width axis (size adjustment) of the booklet maker is in the process
of adjusting. Wait for the booklet maker to finish before pressing
.
Change feed output to front The collator's base is not set up correctly for the current job. Change the
paper path to feed to the front of the collator.
Change feed output to rear The collator's base is not set up correctly for the current job. Change the
paper path to feed to the rear of the collator.
Change feed path down The collator's base is not set up correctly for the current job. Change the
paper path to feed down.
Check fuse A fuse may have blown in the drive unit. Contact your local Watkiss service
department.
Conveyor Jam A paper jam has occurred in the bottom of the conveyor. Remove the rear
guard and clear the jam. Touch
INCH
to clear any partial sets from the
conveyor.
Emergency stop The emergency stop button has been pressed. Turn the emergency stop
button clockwise to release it.
Fuse blown A fuse has blown on the Motor Drive PCB in the drive unit. Contact your
local Watkiss service department.
Fuses blown Fuses have blown on the Motor Drive PCB, in the drive unit. Contact your
local Watkiss service department.
INITIALISING BINS The bins in the collator are being checked. If this message appears
regularly, contact your local Watkiss service department.
Motor Stalled There may be a bad jam causing the conveyor to lock. Clear the jam.
Touch
INCH
to clear any partial sets from the conveyor. If the Vario does
not restart, a fault may have occurred in the drive unit: contact your local
Watkiss service department.
No power to stacker Check that the stacker is plugged into a suitable mains supply, and is
switched on.
No Response The bins in the collator have not initialised properly. Switch the machine
off and then on again. If the problem persists, contact your local Watkiss
Service Department.
Output path deflector
changed The paper path has been altered on the collator's base. Select the correct
paper path before restarting the job.
Message Meaning