Watkiss Vario, Operating Manual

Page: 50 / 110

46
will raise the tray height, whilst turning it in the - direction
will lower the tray height.
Removing the Outer Edge Flicks
Under some circumstances, especially when collating
very light weight and flimsy paper, the edges of the sheets
may catch on the outer edge flicks and become creased.
These can therefore be removed by first pushing the edge
flick control lever fully downwards (so the edge flicks are
in their outermost position), then slide the edge flick to
the right and pull out. The control lever should then be
returned to its operating position to allow the inner edge
flicks to function normally. Be sure to replace the edge
flicks on completion of the job.
Spring Steel Edge Flicks
When collating stiff board it may be necessary to remove
the outer edge flicks and to replace the inner ones with
the optional spring steel edge flicks (P/No. 909-985).
Additional Sucker Configurations
Certain stocks may require different sucker/plug config-
urations to those previously detailed.
The following suggested settings are a recommendation
only. Paper characteristics vary and therefore any partic-
ular stock may require settings different to those shown
below.
Control Knob (Hidden)
Edge Flick Tray Height Switch Blow Nozzles
Paper Stack
Correct Height of Paper Stack in Relation to Blow Nozzles
Edge Flick
Spring Steel Edge Flick