Watkiss Vario, Operating Manual

Page: 74 / 110

70
• Ensure that the RCS bypass lever is in the down
position (In the up position sets will still be delivered to
the rear of the collator, but will feed out below the RCS).
Adjusting the Collator
Move the set divert lever to the upper position (for delivery
to the rear).
Error Messages
Various error messages will be shown on the display for
any of the following reasons:
• There is a paper jam in the stapler
• There is a problem with the staple head
• The staple cartridge is nearly finished
• The lid of the stapler unit is open
For more information about these messages, see p.85.
Loading the Staple Cartridge
The RCS uses staple cartridges, each holding 5,000
staples. These can be reordered from your Watkiss sup-
plier quoting part number 800-020.
• Open the access flap and release the red cartridge
retaining spring by pushing firmly to the right
• Pull out the used cartridge
• Prepare the new cartridge by pulling out a small amount
of staple strip, and tearing off along the tear line
• Insert the new cartridge pushing it firmly into place