Watkiss Vario, Operating Manual

Page: 70 / 110

66
Adjust the position of the support posts by twisting anti-
clockwise to release, sliding to about 5mm (¼") from the
edge of the stack and then re-tightening.
Adjust the position of the X-Jogger itself. Slide it further
in or out so that the back edge of the stack is level with
the outfeed of the collator.
Adjust the direction of the air blast towards the bottom
edge of the stack, using a combination of air pipes and
connectors to suit the paper size.
Select
OSCILLATE
in either the
BASIC
or
BATCH
menu (if
required) from the control panel menu and run a test set.
If needed, fine-adjust the position of the sidelays, support
posts and air blast to achieve a neat stack.
Jogging Adjustment
If necessary, adjust the amount of vibration via the knob
on the top of the motor housing (just above the mains On/
Off switch). Use the minimum amount of vibration that will
successfully jog the stack.
Straight Stack Liner
A Straight Stack Liner is available for the X-Jogger to
increase straight stacking performance, especially when
collating carbonless paper (Part No. 914-304).
Using the Jogger with a Bench Top Vario
The X-Jogger cannot be used with a standard bench top
base. However, it can be used with an oscillating bench
base. Please refer to your Watkiss supplier for more
information.
STRAIGHT JOGGER Setting up the Jogger
Wheel the Straight Jogger into a central position under
the collator (as shown in the diagram for the X-Jogger
p.65). Ensure the local control switch is in the off position
(green strip not visible). Connect the jogger to the mains
supply and turn on the red mains on/off switch.