Watkiss Vario, Operating Manual

Page: 69 / 110

65
9
Joggers
There are two types of jogger available for the Vario, the
X-Jogger and the Straight Jogger. The X-Jogger straight
or offset stacks whilst the Straight Jogger is used when
set separation is not required.
X-JOGGER Setting Up the Jogger
Position the X-Jogger under the collator as shown. Con-
nect the jogger to the mains supply and switch on.
Plug the jogger into the socket on the underside of the
floor base via the interconnection cable. The cable will
only fit in to one of the sockets (see p.59).
Take a few sheets of the stock to be collated and place
them in the stacker offset by 20°. Use the hand wheel to
adjust the sidelays to suit the width of the stack.
Adjust the bottom sidelay so that the middle of the sheet
is over the middle of the stacker tray. You can check this
by folding a sheet in half (as dotted line in photo) and
checking that the fold on the left and right edge is equal
distances (’X’) above and below the angle in the sidelays.
The X-Jogger with A3 (11 x 17")
Paper
X
X
The X-Jogger with A4 (8½ x 11") Paper
Stacker Air Blast
Width Adjustment
Support Post
Bottom Sidelay
Adjustment