Watkiss Vario, Operating Manual

Page: 61 / 110

57
NON-STANDARD
PAPER SIZES
For non-standard paper sizes a different method is re-
quired.
Straight Stacking
Take a few sheets of the paper and align them centrally
between the guide marks for the next standard size up.
Position the sidelays on the base leaving a 5mm (¼”) gap
between the inside corner of the sidelay and the paper.
Offset Stacking
For offset stacking, setup as above and then move the
right sidelay 25mm (1") to the right whilst keeping it
aligned with the bottom edge of the paper.
As before, the sidelays' position can be adjusted after
initial collating to ensure neat stacking.
STACKING A5
SHEETS
It is recommended that A5 (6 x 8½") sheets are stacked
in landscape orientation whenever possible as this will
give better results.
PAPER GUIDES The purpose of the paper guides is to make the paper
rigid in order for the sheets to travel smoothly into the
stacker. They can be flipped up or down, and under
normal circumstances should all be down except EITHER
the middle one OR the outermost ones relative to the sheet
size (the optimal positioning will vary with sheet size,
direction of grain, paper weight etc.).
25mm (1")
Offset Stacking Sidelay Positioning