Watkiss Vario, Operating Manual

Page: 96 / 110

92
Length:
Sheet length as measured by the emitter/sensor
during the test set. Normally zero before the test set has
bee n completed. A small variation from bin to bin in the
reported sheet size is normal.
Ref:
The amount of light passed through the sheet by the
emitter/sensor on the test set. The higher the value, the
less light is passing through the sheet and hence the
thicker (optically) the sheet. This value is updated with a
moving average on every subsequent good feed. The
value range is between 0 and 255.
Power:
This will read either "+" or "-" depending on whether
the emitter/sensor is using the high or low power setting
respectively.
Limit:
The allowed tolerance on either side of the refer-
ence value for sheet opacity variation.
CLEANING CLEANING
turns the conveyor on. Press the red button on
the bin controls to activate the feed clutch for that bin.
Touch
CLEANING
again to switch the conveyor off. Refer
to your operating manual for information on machine
maintenance.
MACHINE OPTIONS Touch
MACHINE OPTIONS
to view the general machine
set-up. Some of the settings can be changed, depending
on the current access level.
MEASUREMENT
Select
MM
or
INCH
as the unit of measurement.
PAUSE TIME
Adjusting the
PAUSE TIME
increases or decreases the
pause time at the end of a batch when
PAUSE / SEPARATE
is selected from the
BATCH
window, or when
PAUSE
is
selected whilst the machine is running.
INTER TOWER DISTANCE
This is an engineer setting for configuring the multi-tower
mode.
NETWORK SETTINGS
The network settings need to be correct in order to link
the Vario to a computer via the Ethernet connection.
Touch
NETWORK SETTINGS
to view the Vario’s IP address
and subnet mask. See the Watkiss Vario GUI Panel
Installation Guide for more information about setting up
a network.