Watkiss Vario, Operating Manual

Page: 73 / 110

69
10
Rear Corner Stapler
The Vario Rear Corner Stapler (RCS) is an optional ac-
cessory that may be fitted onto your Vario. This unit fits
onto the rear of the collator.
Loading the Collator
The sheets should be loaded face down and with the top
page in the bottom bin. The corner to be stapled should
be loaded outermost.
Adjusting the RCS
• Take a sheet of paper the same size as that to be
stapled.
• With the top hinged cover closed, adjust the infeed
sidelays for the sheet width by turning the hand-wheel
so that the sidelays correspond to the appropriate point
on the scale.
• Open the top hinged cover of the corner stapler, this
will cause the sidelays to move to their inner position.
Insert the sheet between the sidelays and make any
fine adjustments required. The sidelays must tidy the
set, yet still allow the sheets to fall freely between them.
• In the orientation in which it is to be stapled, stand the
sheet inside the RCS so that it is resting on the small
rollers. Adjust the top knock by sliding it up or down
so that it is approximately 5mm clear of the edge of the
sheet.
Top knock
Infeed Sidelay Scale
Infeed Sidelays
Infeed Sidelay
Adjustment
RCS Bypass Lever