Watkiss Vario, Operating Manual

Page: 39 / 110

35
Incorrect usage may result in either misfeeds or double
feeds.
Loading the Bins
Place a full stack of paper between the two sidelays in
the base of the tray. Maximum capacity is achieved when
the paper is slightly below the top of the sidelays. Slide
the sidelays inwards to centralise the paper.
Position the rubber endlays on each tray at the end of the
paper stack. The endlay should be underneath and just
clear of the edge of the paper (by about 1mm, 1/16”).
The paper tray raises automatically when the collator
initially starts and thereafter when the tray is loaded. It is
therefore important to load a full stack of paper at a time.
The tray automatically lowers either when the tray is empty
330-351
When the rubber endlay will sit
on the tray extender, position it
so that ’A’ is underneath the
paper stack.
330-351
When the rubber endlay will sit
on the bar across the front edge
of the bin, position it so that ’B’ is
underneath the paper stack and
the step is on the bar.
330-446
When the rubber endlay will sit
within the bin itself, use the spe-
cial endlay 330-446. Position it
so that ’C’ is underneath the
paper stack.
B
A
B
A
Step
C
Note
When collating small sheet sizes, make sure the tray
loaded sensor is not covered by the rubber endlay.