Watkiss Vario, Operating Manual

Page: 88 / 110

84
’BIN # LIFT ERROR'
MESSAGE AND SMALL
GREEN LIGHT IS FLASHING
QUICKLY (• • • •) Too much paper has been loaded
into the bin (note that the grey
button will not raise or lower the
tray) Remove the stock and reload a
smaller quantity:
Sheet Size to: Max Load
340x520mm 100mm
13¼"x20¼" 4"
364x520mm 88mm
14¼"x20¼" 3¾"
An obstruction in the bin has pre-
vented the tray from lowering cor-
rectly. This has caused the tray
lift cable to reverse-wrap and
raise the tray again Remove any obstructions and
then press the grey button, the
tray lift cable will automatically
correct itself
The tray is too low Adjust accordingly (see p.45)
X-JOGGER PROBLEMS
Problem Cause Solution
NOT OFFSET STACKING
OSCILLATE
is not available or not
selected in the
BASIC
or
BATCH
window
Plug X-Jogger into the Vario and
select
OSCILLATE
in the
BASIC
or
BATCH
window
Stacker is not set up correctly Follow set up instructions (see
p.65)
Poor set delivery Adjust drive speed to suit the
stock and if necessary adjust the
paper guides
OSCILLATING BASE PROBLEMS
Problem Cause Solution
NOT OFFSET STACKING
OSCILLATE
is not available or not
selected in the
BASIC
or
BATCH
window
Select
OSCILLATE
in the
BASIC
or
BATCH
window
An obstruction is stopping the
tray from moving Remove obstruction
The sidelays are too tight Readjust the sidelays
SUCTION FEED PROBLEMS
Problem Cause Action