Watkiss Vario, Operating Manual

Page: 81 / 110

77
• Insert the new cable, noose end first, into the hole in
the shaft and pull through (note that the entry hole is
larger than the exit hole).
• Ensure that the cable is wrapped around the shaft to
match the cable on the other side of the tray.
Fitting the Shear Pin
• Open the noose in the end of the cable and then, lifting
the tray with one hand, pass the cable through the hole
in the tray.
• Insert the shear pin through the noose and gently lower
the tray ensuring that the flat side of the pin lies against
the bottom of the tray.
• Raise the tray and ensure that the cable wraps smooth-
ly around the shaft. The cable should wind progres-
sively inwards.
Part No Description
370-203 Tray Lifting Cable (VSCN)
310-444 PL Mould (VSCN) Lift Wire Shear Pin
Note
Two spare shear pins are supplied with each new
suction bin and two spare tray lifting cables are sup-
plied with each new machine