Watkiss Vario, Operating Manual

Page: 89 / 110

85
REPLACING FUSES Your Vario is fitted with two fuses at the mains input. If
either of these fail the machine will not power up.
• Unplug the mains input lead and open the flap on the
fuse holder.
• Pull out each fuse casing in turn and check the fuse.
• Replace if necessary with a fuse of the correct speci-
fication, as detailed below.
Reference
230V machines:
730-018 Fuse, 1.25" (32mm) 7.0A HRC (Quick Acting, F)
115V machines:
730-020 Fuse, 1.25" (32mm) 10.0A HRC (Quick Acting, F)
ERROR MESSAGES Under certain error conditions a message will be dis-
played on the control panel. Some of the error messages
will refer to an individual bin or module address. In this
case the relevant module number will appear where # is
shown below.
Caution!
The Vario system uses double-pole/neutral fusing (ie,
two fuses), so when removing any covers or changing
fuses always first disconnect the machine from the
mains electricity supply by switching off and unplug-
ging the machine
Message Meaning
Bin # double A double feed error has occurred on the bin detailed. This means that the
bin has fed two sheets of paper, instead of one. Check and correct the
faulty set and restart the machine. If the error persists see the Problem
Solving section of the Operating Manual.
Bin # empty The paper tray of the bin detailed is empty. Reload the bin and touch
to continue the job.
Bin # jam A paper jam has occurred in the bin detailed. Touch
INCH
to clear any
partial sets from the conveyor. If the error persists see the Problem Solving
section of the Operating Manual.