VESPA 150, Service Station Manual, Page: 98 / 249

Note: To do this, do not use sharp objects that could damage the closing strip, use gloves to protect
your hands and do not bring your face close to the battery.
The filling process is now complete.
Do not remove the strip of caps under any circumstances, do not add water or electrolyte.
Place the battery down for 1 to 2 hours prior to the charging from the battery.
7) Recharging the new battery
With the above-mentioned procedure, the battery
will have gained around 70% - 75% of its total
electrical capacity. Before installing the battery on
the vehicle, it must be fully charged and then must
be recharged.
If the battery is to be installed on the vehicle
prior to this pre-charged one, the battery will
not be able to exceed 75% charge without jeop-
ardising its useful life on vehicle.
The dry charge battery MF like the completely loa-
ded YTX, must have a no-load voltage between
12.8 - 13.15 V Bring the battery to full charge, us-
ing the 020648Y battery charger:
a - select the type of battery with the red switch on
the left of the panel battery charger panel
b - select NEW on the yellow timer
c - connect the clamps of the battery charger to the
battery poles (black clamp to negative pole (-) and
red clamp to positive pole (+)).
d - Press the red button, as shown in figure.
Electrical system
Vespa Primavera125 - 150 i.e. 3Valvole (2013)
ELE SYS - 98