VeEX VePAL TX300M, User Manual

Page: 278 / 421

Quick Test Setup
Fill out each screen and press
NEXT
to proceed to the next page or
Previous
to go back to the previous screen.
Step 1:
Select the router test interface. "Local unit" denotes a router wrap test while "end-to-end" conducts an end-to-end test.
The frame size for each option listed below is 256 bytes. The following options are available:
1G-1G on local unit: 1G interface is always set to 100% of the line rate.
1G-10G on local unit: 10G interface is always set to 10% of the line rate.
1G-10G with remote test unit: For Copper or Fiber, Controller is set to 100% of the line rate; remote is 100% of the line
rate.
10G-10G with remote test unit: Controller is set to 100% of the line rate; remote is 100% of line rate.
Step 2:
Select the copper/fiber ports to be used in the test. If the copper port is selected, configure the port settings: Auto
Negotiation, Advertisement and Flow Control.
Step 3:
The wavelength for the test ports in use will display at the beginning of Step 3.
Step 4&5: Entering the IP Address
Step 4:
Enter the local IP address for port 1. Press
Apply
and configure the subnet mask address. Press
Apply
and enter the
gateway address. At the end of Step 4, the screen will display a summary of the IP address, Subnet, and Gateway. Tap on any
of the corresponding fields to make any changes, if necessary.
Step 5:
Enter the IP address, Subnet, and Gateway for port 2, following the same procedure detailed in Step 4.
Step 6:
Review the settings for both ports. Press
Start
to begin testing. Pressing
Reconfigure
will restart the Quick Test Setup
and return the screen to Step 1.
TX300S_e-manual_D07-00-064P_RevA00