VeEX VePAL TX300M, User Manual

Page: 215 / 421

E1 RX Data
Go back to top Go back to TOC
11.7 E1 ISDN PRI
Note:
E1 and DS1 ISDN PRI offer identical test options. Setup instructions for both E1 and DS1 are discussed below.
11.7.1 ISDN PRI Call
11.7.1.1 Setup (PRI Call Setup)
Configuration parameters for ISDN PRI Call are as follows:
Page 1
Mode:
TE, NT, or Monitor. In TE or NT mode, the test set can place up to 2 simultaneous data or audio calls on any
primary line
TE (PBX):
Terminating Equipment used when the test set is emulating customer equipment. TE generally uses the
received signal to clock the transmitter.
NT (CO):
Network Terminal is used when the test set is emulating an ISDN switch, such as DMS-100, 5ESS. NT
generally uses the internal clock.
Monitor
: Trace message details:
D Channel decodes help to verify that a call is successfully established, or determine why a call was not
completed by examining the protocol cause values.
Call Control:
The Q.931 specification indicates which type of ISDN switch is to be tested. AT&T and NTI are only
available for DS1.
AT&T relates to the 5ESS switch
NTI relates to the Northern Telecom DMS-100 switch
ETSI is the ETSI standard
Channel Config:
23B+D, 46B+2D, 47B+D, or 23Bx2 in DS1; Single/Dual PRI in E1.
D Channel:
Designates the time slot to transmit D Channel messages. The D Channel decoder helps to verify that a call
is successfully established, or determine why a call was not completed by examining the protocol cause values.
My num type:
Unknown, International, National, or Local
My num plan:
Unknown, Telephony, or Private
TX300S_e-manual_D07-00-064P_RevA00