VeEX VePAL TX300M, User Manual

Page: 217 / 421

The symbols RDY and OOS are port status indicators. Below each status is the port number.
Status Description
OOS
indicates that the port is
Out of Service
and will be unable to run any tests. If OOS displays on the
unit, check for proper connection between the physical ports and cables and that both units' setup screens
are configured correctly. The port number in this example is 2.
RDY
indicates that the test port is
Ready
for use.
The port number in this example is 1.
Go back to top Go back to TOC
11.7.1.2 Signal
Line Code:
HDB3 or AMI
Clock Source:
Internal, External, Rx, or Offset. If the test set is in TE mode, select Rx to receive timing signals from the
master clock
Termination:
Terminated, Monitor, or Bridge
DS1/E1 Framing:
Unframed, PCM31, PCM31C, PCM30, PCM30C for E1; AIS or Idle for DS1.
Signal
Main Setup
Connect to the CPE or Network.
Connect headsets to the 2.5mm audio jack port (or use the 3.5mm to 2.5mm headset adaptor)
Select Call Control protocol type
Select the emulation type (Should be TE on the other NT)
Go back to top Go back to TOC
11.7.1.3 Call - Voice and 3.1K Audio Setup
Press Call to bring up the Call Setup menu. Voice and 3.1K Audio calls follow the same setup procedure. Both are outlined
below:
TX300S_e-manual_D07-00-064P_RevA00