Turnstiles Traffic H1, Operating Instructions Manual

Page: 53 / 101

Electrical connection
5816,0013US / Version 02 53
8.4.6 Digital outputs and output relays
Technical data

See page 30, chapter 4.2.
NOTE!
The digital output functions can be freely
parameterised.

For output parameterisation, see
separate document "Description of control units
MGC and MGC Pro for MHTM
TM
MicroDrive
barriers".
Factory setting
Clamp Description Function
DO1 Digital output 1 Locking
DO2 Digital output 2 Impact detection
DO3 Digital output 3 Loop active A
DO4 Digital output 4 Loop active B
NO1 Relay 1 Open
NO2 Relay 2 Closed
NO3 Relay 3 Error
NO4/NC4 Relay 4
Boom angle 30
–
85°
NO5/NC5 Relay 5
Boom angle 60
–
85°
NO6/NC6 Relay 6 Service mode active
Table 9: Factory settings "Digital outputs" and "Relay outputs"
8.5 Checking the electrical connection
The following points have to be checked after the electrical
installation of the barrier:
 Are the following electrical protective devices installed:
2-pole main switch, circuit breaker and ground fault circuit
interrupter?
 Is the power cable connected to the terminal in compliance with
chapter 8.3?
 Are the induction loops connected according to the wiring
diagram?
 Are the control lines connected according to wiring diagram?
 Are the safety plates in the area of the lever system
assembled?
 Have all barrier housing covers been properly assembled?
Traffic H1 Swing Gate Horizontal Barrier
www.TURNSTILES.us | patrick.mcallister@TURNSTILES.us | 303-670-1099