Electrical connection
50
5816,0013US / Version 02
Connecting the control lines
3.
Guide control lines into the connection space through the
cable openings.
Place control lines properly in the barrier housing. The
control lines must not get into moving components.
Attach control lines clamps and cable ties. The clamps can
be removed from the rail by slight compression and
relocated in the desired position. The cable ties can be
attached to the metal tabs.
4.
Connect control lines according to wiring diagram. Control
lines must be wired so that no damage could occur due to
moving parts.
See page 91, chapter 16.1 "Wiring diagrams".
5.
Install the safety plates in the area of the lever system.
Mag00518a
1 2
3
4
Fig. 16: Connecting the control lines
1 Control
unit
2
Cable tie metal tabs
3 Cable
opening
4 Cable
clamps
8.4.1
Connecting safety loops and / or safety scanners
As safety devices, you must connect safety loops or safety scanner
to the control unit. Safety loops must only be connected to monitor
vehicles.
If you connect a safety loop, the barrier closes only after the safety
loop is clear. If you connect a safety scanner, the barrier closes
only after the safety scanner is clear.
The danger area of 2 ft (610 mm) as defined in chapter 2.7 must
be maintained at any time, even in case additional safety devices
are installed.
Traffic H1 Swing Gate Horizontal Barrier
www.TURNSTILES.us | [email protected] | 303-670-1099
