Assembling flange and barrier arm
5816,0013US / Version 02
61
6.
Mount the clamp holder with the two slotted nuts at the front of
the barrier arm. Mount the clamp holder so that it can still be
moved on the barrier arm.
Mag00582
Fig. 23: Mounting the clamp holder
7.
Turn out the threaded and fork terminal from the turnbuckle
about halfway.
8.
Mount the fork terminal on the clamp holder. For this, push the
bolt through the bore and secure it with the safety pin.
Mag00516a
1
2
3
4
Fig. 24: Mounting the lower anchor support
9.
Move the clamp holder until the spiral rope is slightly tensed.
10. Tighten the 8 screws of the clamp holder.
Torque wrench: 13 AF
Tightening torque: 11.8 lbf ft (16 Nm)
11. Turn the turnbuckle until the middle area of the barrier arm is
horizontally aligned. Check alignment with spirit level.
NOTICE! To avoid destruction of the anchor support, hold the
threaded terminal with a fork wrench.
Switch on the barrier
12. Switch on power supply.
Traffic H1 Swing Gate Horizontal Barrier
www.TURNSTILES.us | [email protected] | 303-670-1099
