Turnstiles Traffic H1, Operating Instructions Manual

Page: 78 / 101

Malfunctions
78 5816,0013US / Version 02
Number Description Possible cause Corrective action
8130
WARNING Note monitoring Communication with a plug
module was interrupted.  Check if all plugged
modules are listed in the
main menu.
 Perform reset.

See
page 81, chapter 12.4.
 Contact service if required.
Table 11: Event, warning and error messages – logic control (control unit)
12.3.2 Event, warning and error messages – Motor GW
Number Description Possible cause Corrective action
2220
WARNING Overcurrent Overcurrent was recognised  Warning may appear in
connection with impact.

If no impact took place,
check the cables.
 Contact service if required.
3211
WARNING Overvoltage Overvoltage was recognised  Warning may appear in
connection with impact.
 If no impact took place,
check the cables.
 Contact service if required.
3221
WARNING Undervoltage Undervoltage was recognised  Check wiring.
 Check if there is an overload
of the 24 V DC-supply.
Supply additional consumer
via separate mains unit.
 If required, contact Service.
4210
WARNING Overtemperature
A high temperature was
recognised.

Check motor temperature
via display. The temperature
must be below 100 °C.

See separate document
"Description of control units
MGC and MGC Pro for
MHTM
TM
MicroDrive
barriers", chapter "Motor
GW".
 Contact service if required.
4220
WARNING Derating error Motor power intake is reduced
to avoid further temperature
increase.  Remove impermissible
attachments
 Reduce speed of the barrier
arm.
 Contact service if required.
Traffic H1 Swing Gate Horizontal Barrier
www.TURNSTILES.us | patrick.mcallister@TURNSTILES.us | 303-670-1099