Repair
86
5816,0013US / Version 02
Remove anchor support and barrier
arm
5.
If present, remove anchor support. For this, proceed in the
reverse order as for mounting.
6.
Disassemble the barrier arm. For this, proceed in the reverse
order as for mounting.
See page 58, chapter 9.3.
Mount barrier arm
7.
Push the new barrier arm onto the flange.
8.
Attach the barrier arm to the flange using the screws.
Torque wrench: 8 AF
Tightening torque: 12 Nm
Check the swivel range of the
barrier arm
9.
Switch on power supply.
10. Switch the "Service" switch on the control unit. The LED lights
red. The display backlighting flashes.
11. Open and close the barrier manually to check the swivel
range.
Middle left button : Manually open the barrier.
Middle right button
: Manually close the barrier.
Sett close direction
12. If the close direction is incorrect, change the close direction
via the parameter "Close direction".
See separate
document "Description of control units MGC and MGC Pro for
MHTM
TM
MicroDrive barriers", chapter "Close direction".
13. Switch the "Service" switch on the control unit. The LED must
light green.
14. Switch off power supply.
Mount anchor support
15. If present, mount anchor support.
See page 58,
chapter 9.3.
16. Install the rear door of the barrier housing.
17. Install the rear cover of the barrier housing.
18. Lock the lock at the rear door.
Traffic H1 Swing Gate Horizontal Barrier
www.TURNSTILES.us | [email protected] | 303-670-1099
