Assembling flange and barrier arm
5816,0013US / Version 02
57
Assemble flange at barrier arm
10. Loosen screws at the flange.
11. Push the flange onto the flange shaft and align it. Observe
motion direction and freedom of movement.
12. Clamp the flange to the flange shaft using the screws.
Torque wrench: 8 AF
Tightening torque: 51.6 lbf ft (70 Nm)
90°
Mag00513
Fig. 18: Assembling flange
Check the swivel range of the
barrier arm
13. Switch on power supply.
14. Switch the "Service" switch on the control unit. The LED lights
red. The display backlighting flashes.
15. Opening and closing the barrier manually; Check the swivel
range again via the flange.
Middle left button : Manually open the barrier.
Middle right button
: Manually close the barrier.
16. If required, check the alignment of the flange.
17. Switch the "Service" switch on the control unit. The LED must
light green.
18. Install the rear door of the barrier housing.
19. Install the rear cover of the barrier housing.
20. Lock the lock at the rear door.
Traffic H1 Swing Gate Horizontal Barrier
www.TURNSTILES.us | [email protected] | 303-670-1099
