Safety
14
5816,0013US / Version 02
2 Safety
2.1
Intended use of the barriers
The
MHTM
TM
MicroDrive Traffic barriers are solely intended for
temporarily blocking the access by vehicles and on foot to specific
public or industrial areas and leaving of these areas by specific
motor vehicles and/or persons, or to temporarily lock lanes or
paths.
The barrier must only be controlled by a person or by external
systems in the manual modes. The setting of automatic operating
mode at the MGC control unit is not intended for these barriers.
The barrier must be monitored with induction loops and/or safety
scanners.
To reach the required minimum protection level in the industrial
area, the entire swivel range of the barrier arm must be monitored
by a contact-free safety device. We recommend using safety laser
scanners as a safety device.
In the public area, only the slow-moving horizontal barriers
TRAFFIC H1L at the slowest speed must be used to avoid
exceeding the permitted impact forces.
The barrier must only close against flowing traffic. The barrier must
never close with flowing traffic. Exceptions are systems with
changing crossing traffic in industrial areas.
Permitted use: Closing of the
barrier against traffic
Mag00570
Fig. 1: Closing of the barrier against traffic
Forbidden: Closing of the barrier
with traffic
Mag00572
Fig. 2: Closing of the barrier with traffic
Traffic H1 Swing Gate Horizontal Barrier
www.TURNSTILES.us | [email protected] | 303-670-1099
