Triumph Adler P-3521DN, Advanced Operation Manual

Page: 89 / 130

Using the Operation Panel 2-69
Password (Administrator Password input)
To set up the Sleep Level settings, you must enter an administrator ID
and administrator password. For information on how to set the
administrator password, refer to
Administrator (Administrator
settings) on page 2-81 .
1
Once you have entered the correct ID in the previous step (ID
(Administrator ID input)), the message display shows
Password
(Administrator password input) and a blinking cursor (
_
).
2
Press
U
or
V
to increase or decrease, respectively, the value at the
blinking cursor. Enter the specified password. Use Y and Z to move
the cursor right and left. Enter a password consisting of between 0 (no
settings) and 16 numbers.
3
Press [OK] . The Sleep Level settings screen appears.
Sleep Level (Sleep level setting)
There are two sleep modes with different levels of sleep: Quick
Recovery and Energy Saver.
Quick Recovery Mode : The recovery from the sleep mode is faster than
when using Energy Saver mode.
Energy Saver Mode : This makes it possible to reduce energy
consumption even further than with Quick Recovery mode. With Energy
Saver mode, you can set whether to enable the Energy Saver mode for
each separate function.
IMPORTANT Cautions when setting the Energy Saver mode
• The data stored on the RAM disk is deleted when the machine goes
into Energy Saver mode.
• The machine will not recover from Energy Saver mode if printing data is
received from a computer via a USB cable.
• An ID card is not recognized when in Energy Saver mode.
1
After entering the administrator ID and password, press U or V
repeatedly until
>>Sleep Level
appears.
2
Press [OK] . A blinking question mark (
?
) appears.
3
Press U or V to select
Quick Recovery
or
Energy Saver
.
4
Press [OK] .
5
Press [MENU] . The display returns to
Ready
.
Password
_
Note If you enter the incorrect administrator ID or password,
the message
Wrong ID
or
Wrong Password
appears and
the input screen then reappears. Re-enter the ID or password
correctly.
Note
For information on the Quick Recovery mode and Energy
Saver mode, refer to the Connecting and Printing section in the
Operation Guide .
Sleep Level Set. menu is not displayed when the optional network
interface kit (IB-50) or wireless network interface kit (IB-51) has
been installed.
>>Sleep Level
? Energy Saver