Triumph Adler P-3521DN, Advanced Operation Manual

Page: 84 / 130

2-64 Using the Operation Panel
2
Press [OK] . The message display shows a blinking cursor (
_
).
3
Press U or V to increase or decrease the value at the blinking cursor
and set the desired time. The time must be set between 005 and 495
seconds, in 5-second increments. Use
Y
and
Z
to move the cursor
right and left.
4
Press [OK] .
5
Press [MENU] . The display returns to
Ready
.
Low Power Timer (Low Power Mode timer timeout time)
You can adjust the length of time the printer waits before entering Low
Power Mode in the absence of a print job.
The printer reverts to normal operation mode when the printer receives a
print job or
[GO] is pressed on the operation panel. The default time is
1
minute.
1
After entering the administrator ID and password, press U or V
repeatedly until
>>Low Power Timer
appears.
2
To change the timeout time, press [OK] . A blinking cursor (
_
)
appears.
3
Press U or V to increase or decrease the value at the blinking cursor
and set the desired time. The timer can be set between
1
and
120
min (for Europe) or
1
and
240
min (except for Europe). Use Y
and Z to move the cursor right and left.
4
Press [OK] .
5
Press [MENU] . The display returns to
Ready
.
Sleep Timer (Sleep timer timeout time)
You can adjust the length of time the printer waits before entering Auto
Sleep in the absence of data.
The printer reverts to normal operation mode when the printer receives a
print job, or
[GO] is pressed on the operation panel. The default time is
15
minutes (for Europe) and
1
minute (except for Europe).
1
After entering the administrator ID and password, press
U
or
V
repeatedly until
>>Sleep Timer
appears.
2
To change the timeout time, press [OK] . A blinking cursor (
_
)
appears.
3
Press U or V to increase or decrease the value at the blinking cursor
and set the desired time. The timer can be set between
1
and
120
min (for Europe) or
1
and
240
min (except for Europe). Use
Y
and Z to move the cursor right and left.
4
Press [OK] .
>>Panel Reset Timer
090sec.
>>Low Power Timer
005 min.
Note
Calibration is automatically executed before the printer
reverts to normal operation mode.
>>Sleep Timer
015 min.