Toyota Corolla Hybrid 2019, Owner'S Manual

Page: 140 / 491

138
COROLLA HV_ 国瑞 _GE
3-2. Opening, closing and locking the doors
●
When the lock operation is performed
using the lock sensor, recognition sig-
nals will be shown up to two consecu-
tive times. After this, no recognition
signals will be given.
●
If the door handle becomes wet while
the electronic key is within the effec-
tive range, the door may lock and
unlock repeatedly. In that case, follow
the following correction procedures to
wash the vehicle:
• Place the electronic key in a location 2
m (6 ft.) or more away from the vehi-
cle. (Take care to ensure that the key
is not stolen.)
• Set the electronic key to battery-sav-
ing mode to disable the smart entry &
start system. (

P.136)
●
If the electronic key is inside the vehi-
cle and a door handle becomes wet
during a car wash, a message may be
shown on the multi-information dis-
play and a buzzer will sound outside
the vehicle. To turn off the alarm, lock
all the doors.
●
The lock sensor may not work prop-
erly if it comes into contact with ice,
snow, mud, etc. Clean the lock sensor
and attempt to operate it again.
●
A sudden handle operation or a han-
dle operation immediately after enter-
ing the effective range may prevent
the doors from being unlocked. Touch
the door unlock sensor and check that
the doors are unlocked before pulling
the door handle again.
●
If there is another electronic key in the
detection area, it may take slightly
longer to unlock the doors after the
door handle is gripped.
●
Fingernails may scrape against the
door during operation of the door han-
dle. Be careful not to injure fingernails
or damage the surface of the door.
■
When the vehicle is not driven for
extended periods
● To prevent theft of the vehicle, do not
leave the electronic key within 2 m (6
ft.) of the vehicle.
●
The smart entry & start system can be
deactivated in advance. (

P.462)
●
Setting the electronic key to bat-
tery-saving mode helps to reduce key
battery depletion. (

P.136)
■
To operate the system properly
● Make sure to carry the electronic key
when operating the system. Do not
get the electronic key too close to the
vehicle when operating the system
from the outside of the vehicle.
Depending on the position and holding
condition of the electronic key, the key
may not be detected correctly and the
system may not operate properly. (The
alarm may go off accidentally, or the
door lock prevention function may not
operate.)
● Do not leave the electronic key inside
the trunk.
The key confinement prevention func-
tion may not operate, depending on
the location of the key (the inside
edge of the trunk), conditions (inside a
metal bag, close to metallic objects)
and the radio waves in the surround-
ing area. (  P.134)
■
If the smart entry & start system
does not operate properly
●
Locking and unlocking the doors:

P.441
●
Starting the hybrid system:

P.442
■
Customization
Some functions can be customized.
(

P.462)
■
If the smart entry & start system
has been deactivated in a custom-
ized setting
● Locking and unlocking the doors: Use
the wireless remote control or
mechanical key. (  P.126, 441)
● Starting the hybrid system and chang-
ing power switch modes:  P.442
● Stopping the hybrid system:  P.170
COROLLA HYBRID_OM_General_OM12M44E