Toshiba TR PMIU, User Manual, Page: 97 / 182

87
Ret. Basic Parameters, Ret. I/O Parameters, Ret. Frequency Parameters, Ret. Drive mode
Parameters, Ret. Torque Performance, Ret. Accel/Decel Time Parameters, Ret. Protection
Parameters, Ret. Panel Parameters, Ret. Communication parameters, Ret. Reservation Area
parameters
These are basically same to previous parameters, but if “Ret.” is referred to prefix, the value is written in both
of RAM area and EEPROM area of INV. Set value is kept when the power of INV is turned OFF. The INV is
operated in wrote parameters after rebooting.
EEPROM has limitation of the number of times to writing. Do not exceed 10000 times.
Current status
Only AFC90 is available. Current trip code is stored. If no, 0 is stored. The past 4 trip code is stored to AFE10,
AFE11, AFE12, and AFE13. About meanings of trip cord, refer serial communication manual of the INV.
Frequency monitoring
Basically same to Monitoring frequency. Real-time output frequency value is stored, so if INV is trip, the value
become to 0.
State monitoring
Monitor parameters. You can use input terminal of INV, and panel key of INV front panel as input of PMIU unit.
Refer serial communication manual of the INV.
5
5 5
5.
. .
.3
3 3
3.
. .
.5
5 5
5 The tags of Toshiba T series, Toshiba (Link port) series PLCs
Connect Toshiba controller. If you set value to these tags, the value is set to corresponding register of
controller.
About detail of these registers, refer the manual of controller.