Tokyo Keiki UFP-20, Installation & Operation Manual

Page: 57 / 218

1-46
(2) Installation wizard for massmeter with 1path/1pipe or 2path/1pipe
This portable unit can be selectable from “flow meter”, “mass meter” and “heat meter”.
Also “1path / 1pipe (1 location)”, “2path / 1pipe (1 location)” and “1path / 2 pipe (2 locations)” can
be selected on each meter mode.
Here you can see easy-setup procedure (Installation Wizard) for meter type with “1path / 1pipe (1
location)”, “2path / 1pipe (1 location)” for “mass meter”.
If you would like to change each value independently through the advanced setup menu
(3:<Advanced Setting>), please refer to the Chapter 2.
Required parameters
Before started, please confirm following value for input.
•
Diameter or
the circumference of the pipe
•
Thickness of the pipe
•
Material of the pipe
•
Thickness of the lining (if any)
•
Material of the lining (if any)
•
Fluid type
Table 1.2.7-1 Sample of item parameters
Meas. Setting 1path/1pipe or 1path/2pipe
Filename 100/Steel/1M
Pipe Diameter 114.30 mm
Pipe Thickness 4.50 mm
Pipe Material Carbon Steel
Lining None
Fluid Type Water
Sensor Type UP10AST
Mass Unit kg/h
Mass Total Unit kg
Note1: Check “Meter Type” set as “mass meter” on the following directory.
Menu – 7: System – 2: Measuring Setting – 2: Meter Type ; mass meter
Note2: Check “Path” set as “1path/1pipe” or “2path/1pipe” on the following
directory.
Menu – 7: System – 2: Measuring Setting – 2: Path ; x path / 1 pipe